Why not learn more about Resources?

Beginner’s Guide to Crown Molding and Pot Light Installation Crown molding and pot lighting installation can be done DIY using the proper tools and equipment, and having the right skills, but it can also be intimidating because walls are not always flat and nailing can be difficult. How can you achieve a beautiful crown molding? For a more dramatic crown, we will teach you how to install a crown molding that has the combination of standard crown molding with two-pieces of base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. If you plan using a light-colored stain, choose pieces with the same color or tone, and crown molding is usually installed with the use of handsaw, miter box, and hammer. You can choose to install your crown molding using a brad nailer and miter saw for better results and faster work. If you want a rich and larger look od your crown molding, you can combine it with other types of trim like those with contrasting woods to achieve a two-tone effect. Unlike one-piece crown wherein you need to drive nails where there is framing behind the drywall, you can use a built-up crown for better nailing. You need to chalk lines in order to have the right position for the rail trim, marking at ceiling joists and studs so you will know where to drive the nails, and most carpenters draw lines and marks on the walls and ceiling, then just hide them with paint. An easier method is sticking bands of 2 inches wide masking tape to the ceiling and walls. Tape will not stick properly if the walls or ceilings are just newly painted, so you need to wait for a couple of weeks before using tape. Install the trim over the tape, leaving the tape in place for wall and ceiling protection when finish or paint the trim. For the actual job, add the piece right to the first piece and work around the room following the same direction to make the most of the 45-degree cuts with a miter saw. It makes your job a lot easier to hold, cutting marks easier to see. You have to miter the ceiling rails both outside and inside corners. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. You can check the best crown molding and installation companies and get real reviews now!The 10 Best Resources For Moulding

The 10 Best Resources For Moulding